Installation of
automatic gas
separator
1.
Check that all O-rings are present and that they are
undamaged. Lubricate them with soapy water or
similar to make installation easier.
Press the gas separator into place. Fit the clip. Twist
the clip to ensure that it fastens properly.
Place the bracket in position, parallel with the outer
edge. Secure the bracket with a screw. Use a
socket wrench, size 10 mm.
2.
Assemble the parts of the safety valve. Ensure that
the arrow for the outlet is pointing down, as illus-
trated.
3.
Then fit the safety valve with the associated pipes.
The safety vale must be at an angle of 45°. Fit the
clip. Twist the clip to ensure that it fastens properly.
4.
Install the non-return valve. Fit the clip. Twist the
clip to ensure that it fastens properly.
NIBE S2125Chapter 2 | Delivery and handling14
To Next Page
Loading...
