INSTALLATION AREA
The distance between S2125 and the house wall must be at least 350 mm, but not more than 500 mm in locations
that are exposed to the wind. The free space above S2125 must be at least 1,000 mm. The free space in front
must be at least 1,000 mm for any future servicing.
350 mm
Fritt utrymme bakom
Fritt utrymme framför
dock 1000 mm för ev. framtida service
Min. avstånd
vid användning
av flera F2300
600 mm
1000 mm
400 mm
Minimalt
fritt utrymme
600mm
Minimalt
fritt utrymme
Minimum free
space
Minimum free space
Minimum distance during use
of several S2125
600 mm
600 mm
At least 1,000
mm
400 mm
Free space in front for any future servicing
350 – 500 mm
Free space behind*
* The space behind must not exceed 500 mm in locations that are exposed to the wind.
Condensation
The condensate drain pan collects and leads away the
condensation water.
NOTE
It is important to the heat pump function that
condensation water is led away and that the
drain for the condensation water run off is not
positioned so that it can cause damage to the
house.
Condensation run-off should be checked regu-
larly, especially during the autumn. Clean if
necessary.
• The condensation water (up to 50 litres/24 hrs) that
collects in the trough should be routed away by a pipe
to an appropriate drain, it is recommended that the
shortest outdoor stretch possible is used.
• The section of the pipe that can be affected by frost
must be heated by the heating cable to prevent
freezing.
TIP
Pipe with heating cable for draining the con-
densation water trough is not included.
To ensure the function, the accessory KVR 11
should be used.
• Route the pipe downward from S2125.
• The outlet of the condensation water pipe must be at
a depth that is frost free or alternatively indoors (with
reservation for local ordinances and regulations).
• Use a water trap for installations where air circulation
may occur in the condensation water pipe.
• The insulation must seal against the bottom of the
condensation water trough.
11Chapter 2 | Delivery and handlingNIBE S2125