9.
Secure the gas separator to the heat pump using
two screws, one at the top and one at the bottom.
10.
Install the lid that conceals the safety valve.
11.
Screw the flexible pipes into place. The flexible pipes
can be installed angled straight back or down, de-
pending on which of the pipe connections the 90°
bend is installed on. Install the flexible pipes with a
slight bend, so they can absorb any vibrations that
would otherwise be propagated through the building.
NOTE
Don’t forget the flat gaskets.
12.
Check that there is an opening in the insulation, to
allow any liquid and gas from the safety valve and
the gas separator to escape.
NIBE S2125Chapter 2 | Delivery and handling16
To Next Page
Loading...
