Nibe SMO 20 - System Configuration Settings; Holiday Setting

time & date
time & date4.4
time
day
year
month
24 h
12 h
date
Set time and date, display mode and
time zone here.
Menu
4.4
TIP
Time and date are set automatically
if the heat pump is connected to
NIBE NIBE Uplink. To obtain the
correct time, the time zone must be
set.
language
language4.6
Choose the language that you want
the information to be displayed in
here.
Menu
4.6
holiday setting
holiday setting4.7
activated
start date
stop date
heating
hot water comfort
0
economy
If a room sensor is installed and activ-
ated, the desired room temperature
(°C) is set during the time period.
If a room sensor is not activated, the
desired offset of the heating curve is
set. One step is usually enough to
change the room temperature by one
degree, but in some cases several
steps may be required.
Vacation scheduling starts at 00:00
on the start date and stops at 23:59
on the stop date.
Menu
4.7
TIP
Complete holiday setting about a day before your return so that room
temperature and hot water have time to regain usual levels.
NIBE™ SMO 20Chapter 3 | SMO 20 – at your service56