Menu 5 - SERVICE
OVERVIEW
5.1.1 - hot water settings *5.1 - operating settings5 - SERVICE
5.1.2 - max flow line temperature
5.1.3 - max diff flow line temp.
5.1.4 - alarm actions
5.1.5 - fan sp. exhaust air *
5.1.6 – fan sp. supply air*
5.1.12 - addition
5.1.14 - flow set. climate system
5.1.22 - heat pump testing
5.1.23 - compressor curve
5.1.25 - time filter alarm*
5.2.2 - installed slaves5.2 - system settings
5.2.3 - docking
5.2.4 - accessories
5.3.2 - shunt controlled add. heat *5.3 - accessory settings
5.3.3 - extra climate system *
5.3.4 - solar heating *
5.3.6 - step controlled add. heat
5.3.8 - hot water comfort *
5.3.11 - modbus *
5.3.12 - exhaust/supply air module *
5.3.14 - F135 *
5.3.15 - GBM communications module *
5.3.16 - humidity sensor *
5.3.21 - flow sensor / energy meter
5.4 - soft in/outputs
5.5 - factory setting service
5.6 - forced control
5.7 - start guide
5.8 - quick start
5.9 - floor drying function
5.10 - change log
5.11.1.1 - heat pump5.11.1 - EB1015.11 - slave settings
5.11.1.2 - charge pump (GP12)
5.11.2 - EB102
5.11.3 - EB103
5.11.4 - EB104
5.11.5 - EB105
5.11.6 - EB106
5.11.7 - EB107
5.11.8 - EB108
5.12 - country
* Accessory needed.
Go to the main menu and hold the Back button in for 7
seconds to access the Service menu.
Sub-menus
Menu SERVICE has orange text and is intended for the
advanced user. This menu has several sub-menus.
Status information for the relevant menu can be found
on the display to the right of the menus.
operating settings Operating settings for the control
module.
system settings System settings for the control mod-
ule, activating accessories etc.
accessory settings Operational settings for different
accessories.
soft in/outputs Setting software controlled in and out-
puts on the input card (AA3) and terminal block (X2).
NIBE SMO 40Chapter 8 | Control44
To Next Page
Loading...
