ACCESSORY CARD AXC 30
An accessory board for active cooling (4-pipe system), extra
climate system, hot water comfort or if more than four charge
pumps are to be connected to SMO 40. It can also be used
for step controlled additional heat (e.g. external electric boiler),
shunt controlled additional heat (e.g. wood/oil/gas/pellet boil-
er).
An accessory board is required if for example an HWC pump
is to be connected to SMO 40 at the same time that the
common alarm indication is activated.
Part no. 067 304
AUXILIARY RELAY HR 10
Auxiliary relay HR 10 is used to control external 1 to 3 phase
loads such as oil burners, immersion heaters and pumps.
Part no 067 309
CHARGE PUMP CPD 11
Charge pump for heat pump
CPD 11-25/75
Part no. 067 320
CPD 11-25/65
Part no. 067 321
COMMUNICATION MODULE FOR SOLAR
ELECTRICITY EME 20
EME 20 is used to enable communication and control between
inverters for solar cells from NIBE and SMO 40.
Part no. 057 188
COMMUNICATIONS MODULE MODBUS 40
MODBUS 40 enables SMO 40 to be controlled and monitored
using a DUC (computer sub-centre) in the building. Commu-
nication is then performed using MODBUS-RTU.
Part no 067 144
COMMUNICATIONS MODULE SMS 40
When there is no internet connection, you can use the access-
ory SMS 40 to control SMO 40 via SMS.
Part no 067 073
CONNECTION BOX K11
Connection box with thermostat and overheating protection.
(When connecting Immersion heater IU)
Part no. 018 893
DOCKING KIT SOLAR 40
Solar 40 means that SMO 40 (together with VPAS) can be
connected to thermal solar heating.
Part no 067 084
DOCKING KIT SOLAR 42
Part no 067 153
ENERGY MEASUREMENT KIT EMK 300
This accessory is installed externally and used to measure
the amount of energy that is supplied for the pool, hot water,
heating and cooling in the building.
Part no. 067 314
ENERGY MEASUREMENT KIT EMK 500
This accessory is installed externally and used to measure
the amount of energy that is supplied for the pool, hot water,
heating and cooling in the building.
Cu pipe Ø28.
Part no. 067 178
EXHAUST AIR HEAT PUMP F135
F135 is an exhaust air heap pump specially designed to
combine the recovery of mechanical exhaust air with air/water
heat pump. Indoor module/control module controls F135.
Part no. 066 075
63Chapter 11 | AccessoriesNIBE SMO 40
11 Accessories
To Next Page
Loading...
