Nibe SMO 40 - 2 Delivery and Handling; Wall Installation; Supplied Components

Wall installation
NOTE
For wall mounting, use screws suitable for the
surface.
120
10
310
35
410
360
215 70
120
Use all mounting points and install SMO 40 upright flat
against the wall without any part of the control module
protruding beyond the edge of the wall.
Leave at least 100 mm free space around the control
module to facilitate access and cable routing on installa-
tion and service.
Caution
Screws for removing the front cover are
reached from underneath.
Supplied components
Room sensorOutside sensor
LEK
Temperature sensorInsulation tape
LEK
Cable tiesAluminium tape
LEK
LEK
LEK
Current sensorHeating pipe paste
Installatörshandbok
SMO 40
Tillbehörskort
Tillbehör
IHB SMO 40 Accessory board
9Chapter 2 | Delivery and handlingNIBE SMO 40
2 Delivery and handling