37NIBE VVM 300
Miscellaneous
Menu 5.9 Outdoor temp. #
This menu shows the outdoor air temperature that the
heat pump measures.
Menu 5.10 Evapor. temp. #
This menu shows the evaporator temperature in the heat
pump.
Menu 5.11 Suction gas temp #
This menu shows the suction gas temperature in the heat
pump.
Menu 5.12 Liquid temperature #
This menu shows the liquid temperature in the heat pump.
Menu 5.13 Hotgas temperature #
This menu shows the hotgas temperature in the heat
pump.
Menu 5.14 Return temperature #
This menu shows the return temperature that the heat
pump measures.
Menu 5.15 Diff. Supply/return
Difference (∆T) between the flow line and return line to/
from the heat pump.
Menu 5.16 Start defrosting #
Manual activation of defrosting procedure in the heat
pump.
Menu 5.17 Return
Return to menu 5.0.
Menu 6.1 Room adjustment
The factor that determines how much a deviation between
desired and actual room temperature is to affect the supply
temperature. If the deviation is 1 °C and the factor is 3, the
supply temperature changes by 3 °C.
The factor can be adjusted between 0 and 10 in incre-
ments of 0.1. Factory setting is 1.0.
Meny 6.2 Shunt system
Here you select which heating system the room adjustment
should affect. Can be set at ”System 1”, ”System 2”, or
”System 1+2”.
Menu 6.3 Roomtemp. setpoint
The desired room temperature is set here.
The value can be adjusted between 10.0 and 30.0 °C in
increments of 0.5 °C. Factory setting is 22.0 °C.
Menu 6.4 Return
Return to menu 6.0.
6.0 Room temperature*
* Requires accessory and activation in menu 9.3.5.
Menu explanation
To Next Page
Loading...
