3
VVM 310 – at your service
Set the indoor climate
Overview
Sub-menus
WHPSHUDWXUH
,1'225 &/,0$7(
DGYDQFHG
VFKHGXOLQJ
RII
For the menu INDOOR CLIMATE
there are several sub-menus. Status
information f or the relevant menu can
be found on the display to the right
of the menus.
temperatur e Setting the temperatur e
for the climate system. The status in-
formation shows the set values for the
climate system.
scheduling Scheduling heating.
Status information "set" is displayed
if you set a schedule but it is not active at the moment, "holiday setting"
is displayed if the vacation schedule is active at the same time as the
schedule (the vacation function is prioritised), "active" displays if any part
of the schedule is active, otherwise it displays "off".
advanced Setting of heat curve, adjusting with external contact, minimum
value for supply temperature, own curve and point offset.
temperature
WHPSHUDWXUH
If the house has several climate sys-
tems, this is indicated on the display
by a thermometer for each system.
Set the temperature (with room
sensors installed and activated):
Setting range: 5 - 30 °C
Default value: 20
The value in the display appears as a
temperature in °C if the heating system is controlled by a room sensor.
Menu
1.1
To change the room temperature, use the control knob to set the desired
temperature in the display. Confirm the new setting by pressing the OK
button. The new temperature is shown on the right-hand side of the
symbol in the display.
25NIBE™ VVM 310Chapter 3 | VVM 310 – at your service
To Next Page
Loading...
Need help?
General
