Nibe VVM 310 - SMS Functionality; SG Ready Function

TIP
All settings made since opening the menu can be reset by marking "reset"
and pressing the OK button.
sms (accessory is required)
SKRQH QXPEHU
DODUP UHFHLYHU
VPV 
Make settings for the accessory SMS
40 here.
Add the mobile numbers that are to
have access to change and receive
status information from the indoor
module. Mobile numbers must include
country code e.g. +46 XXXXXXXX.
If you want to receive an SMS mes-
sage in the event of the alarm mark
the box to the right of the telephone
number.
Menu
4.1.4
NOTE
Telephone numbers provided must be able to receive SMS messages.
SG Ready
DIIHFW KRW ZDWHU
DIIHFW FRROLQJ
DIIHFW SRRO WHPSHUDWXUH
DIIHFW URRP WHPSHUDWXUH
6* 5HDG\ 
This function can only be used in
mains networks that support the "SG
Ready"-standard (Germany).
Make settings for the function "SG
Ready" here.
affect room temperature
Here you set whether room temper at-
ure should be affected when activat-
ing "SG Ready".
With low price mode of "SG Ready" the parallel offset of the indoor tem-
perature is increased by "+1". If a room sensor is installed and activated,
the desired room temperature increases by 1 °C.
Menu
4.1.5
With over capacity mode of "SG Ready" the parallel offset for the indoor
temperature is increased by"+2". If a room sensor is installed and activated,
the desired room temperature increases by 2 °C.
affect hot water
Here you set whether the temperatur e of the hot water should be affected
when activating "SG Ready".
47NIBE™ VVM 310Chapter 3 | VVM 310 – at your service