English – 4
English
PROCEDURE 2 - Memorizing the DTX6 as “First Transmitter”
Run the following procedure only if no transmitters have yet been memorized; otherwise use Procedure 3.
Step 1 Step 2 Step 3 Step 4 ...
main
screen
Auto
Auto
Man
Prog
Man
(perma-
nently ON)
example:
1 2 3
4 5 6
power up the motor several times... (display) 1 time (display) conrm (display) select the GROUP
(1)
... Step 4 Step 5 - end
NOTE:
(1) - This step requires you to select the group (i.e.
transmission channel) to which the automated
system is to be assigned.
example:
1 2 3
4 5 6
3
conrm (permanently ON) hold down ... 3 movements ... release
PROCEDURE 3 - Memorizing the DTX6 as “Second (third, fourth...) Transmitter”
Run the following procedure only if one or more transmitters are already memorized in the automation. If no transmitter has yet been memorized, you MUST
use Procedure 2.
Step 1 - 2 - 3 - 4 Step 5
Step 6
On a new
DTX6, not yet
memorized
Execute step
1 - 2 - 3 - 4
of Procedure 2
10
On an old
transmitter, already
memorized
hold down ... wait ... release 3 times
Step 7 - end
NOTE:
(1) - If the motor moves 6 times, the memory is full (max. 30 transmit-
ters) and the new transmitter could not be memorized.
On a new
DTX6, not yet
memorized
3
hold down ... 3 movements
(1)
... release
To Next Page
Loading...
