Nice DTX6

English – 18
English
E.2
Sending a manual command when the automatic mode on the transmitter is deactivated (“Man”)
In this mode, the user can send a command to any group or set of groups, as follows.
01. Call up the term “Man” on the display (= automatic mode deactivated).
02. Press “sel” repeatedly sending the

 (flashing) cursor through the various groups (note – after group 6, if you wish to return to group 1, press “sel” another 3 times);
then stop the cursor next to the group you wish to select. • Confirm the selection with “ok”: (the cursor

 will stop flashing).
03. If you wish to form a “multiple group”, repeat step 02 for each group you wish to add to the “multiple group”.
04. Now send the command to the selected multiple group with key ▲, n or ▼.
Step 1 Step 2 Step 3 ...
stop/esc
main
screen
Auto
sel
Auto
Man
Prog
ok
Man
(permanently ON)
sel
... to select a
desired Group
1 2 3
4 5 6
example:
several times ... (display) 1 time (display) conrm (display) several times ...
... Step 3 Step 4 (optional) Passo 5 - end
ok
1 2 3
4 5 6
example:
If you wish to form a “multiple group”,
repeat step 03 for each group you wish
to add to the “multiple group”.
conrm (permanently ON) sending the command
F
To send another manual command to a previously selected group
The transmitter stores the last group (or multiple group) in memory selected by the user in memory (See procedure E.2). You can therefore send other manual commands to
the group in question with the ▲, n or ▼ keys without having to select it first.