Nice DTX6

15 – English
English
9 - USING THE TRANSMITTER
This chapter describes how to use the transmitter once it has been installed and programmed.
A
To call up the main screen
You can return to the main screen at any time by repeatedly pressing n/esc until “Auto” starts flashing.
Step 1 - end
stop/esc
The display shows: the flashing “Auto” indica-
tor, the current time, the current day of the week
and the solar time (or summer time).
several times ... (display)
B
To enable automatic mode (“Auto”)
01. Call up the main screen by repeatedly pressing n/esc until Auto starts flashing. Confirm your selection with “ok” (= “Auto” stops flashing).
Step 1 - end
stop/esc
main
screen
Auto
ok
Auto
(permanently ON)
The display shows: the “Auto” indicator per-
manently ON, the current time, the current day
of the week, the solar time (or summer time) and
group 1 flanked by the cursor.
several times ... (display) conrm (display) automatic operation ACTIVATED
Important – If no events have been programmed when automatic mode (“Auto”) is enabled, the transmitter remains inert. In this status it only works if the user sends com-
mands manually.
C
To lock (and unlock) the keys when the automatic mode is operating (“Auto”)
When the transmitter is set to automatic mode (“Auto”) you can prevent inadvertent manual commands or use of the transmitter by unauthorised persons by locking/unlock-
ing the transmitter keys as follows.