EN
English - 4
04. Restore the power supply to the control unit.
3
MEMORISING / DELETING TRANSMITTERS IN THE RECEIVER
The rst one-way transmitter to be memorised in the receiver also denes the encoding system (“O-Code”
(“O-Code/A”) or “FloR” or “TTS” or “Smilo” or “Flo”) that each successive one-way transmitter to be memorised
must have. Transmitters with “BD” encoding can instead be memorised freely, as they are compatible with one-
way transmitters inside the receiver’s memory.
Each single coding allows for exploiting only the functions linked to that specic encoding system.
To verify to which encoding system the transmitters already memorised in the receiver belong, proceed as fol-
lows (Warning! – The receiver must already be connected to the control unit):
Verification of the TYPE OF ENCODING system adopted by the transmitters already memorised
01. Disconnect the power supply to the control unit and then restore
the power.
LED B of the receiver will light up green first then orange. When the
orange LED switches off, count the number of subsequent flashes:
•1greenash = transmitters with O-Code or FloR or TTS encod-
ing system
x 1
•1greenashand1orangeash = transmitters with O-Code or
FloR or TTS + BD encoding system
x 1+1
To Next Page
Loading...
Need help?
General
