Nice OXIBD

5 - English
EN
•2greenashes = transmitters with O-Code (O-Code/A) or FloR
or TTS encoding system
x 2
•2greenashesand1orangeash = transmitters with O-Code
(O-Code/A) or FloR or TTS + BD encoding system
x 2+1
•3greenashes = transmitters with Smilo encoding system
x 3
•3greenashesand1orangeash = transmitters with Smilo +
BD encoding system
x 3+1
•5greenashes = no transmitter memorised
x 5
•5greenashesand1orangeash = transmitters with BD tech-
nology
x 5+1
To change the coding assigned to the rst one-way transmitter memorised, it is necessary to delete from the
memory all the transmitters present (one-way and two-way), by strictly adopting Procedure 5 (Paragraph 3.6)
and choosing the option, “ALL THE RECEIVER MEMORY”.
WARNINGS for carrying out the programming procedures
• During the execution of the programming procedures, refer to Fig. 1 to identify key
A and LED B on the receiver. • To understand the meaning of the icons featured in the
procedure, refer to the table, “Key to the symbols used in the manual”. • The proce-
dures have a limit time; therefore, before implementing them, it is important to read and
understand all the steps to be completed.
1
2
AB
1