Safety information Introduction Product information System configuration
Mechanical
Installation
Electrical Installation
28 Unidrive M Modular Installation Guide
Issue Number: 2
Figure 5-4 Removing the terminal covers (Unidrive M size 9E /10E illustrated)
To remove a terminal cover, undo the screw and lift the terminal cover off as shown.
When replacing the terminal covers the screws should be tightened with a maximum torque of 1 N m (0.7 lb ft).
Figure 5-5 Removing the Unidrive M Rectifier terminal covers and housing
To remove a terminal cover, undo the screw and lift the terminal cover off as shown.
When replacing the terminal covers the screws should be tightened with a maximum torque of 1 N m (0.7 lb ft).
To Next Page
Loading...
