Digitax ST Installation Guide 7
Issue: 7
Person authorized to compile the technical file:
C Hargis
Chief Engineer
Address as above
IMPORTANT NOTICE
These drive products are intended to be used with appropriate motors, sensors,
electrical protection components and other equipment to form complete systems.
It is the responsibility of the installer to ensure that the design of the complete
machine, including its safety-related control system, is carried out in accordance
with the requirements of the Machinery Directive and any other relevant
legislation. The use of a safety-related drive in itself does not ensure the safety of
the machine.
Compliance with safety and EMC regulations depends upon installing and
configuring inverters correctly. The inverters must be installed only by
professional assemblers who are familiar with requirements for safety and EMC.
The assembler is responsible for ensuring that the end product or system
complies with all the relevant laws in the country where it is to be used. Refer to
the Installation Guide.
G.Williams
VP Technology
Date: 8th July 2015
Place: Newtown, Powys. UK
To Next Page
Loading...
Need help?
General