6
Step 3: Locate and Verify the Connector
1. Connect the furnace wiring harness to the RESCUE
®
EZ13 replacement motor to ensure proper fit.
2. Disconnect the furnace wiring harness from the new motor and set it aside.
Step 4: Remove the Original ECM Motor
1. Loosen the set screw on the motor shaft.
2. Remove the screw that secures the belly-band mounting bracket to the original motor and set aside.
3. Remove the original motor from the mounting bracket.
4. Verify that the RESCUE
®
EZ13 motor has the same horsepower and voltage rating as the original
ECM motor.
To Next Page
Loading...
