SP Series
Operating & Safety Instructions
USA – 11/14
Original instructions
3.3.3 MONTHLY SAFETY CHECKS
1) Check the engine oil level (if applicable).
2) Check wheel nuts are secured (torque 110ft lbs / 150Nm).
3) Check that the rotation worm is secured and correctly in mesh. Clean and re-grease.
4) Check the track rod linkage.
5) Inspect brakes for operation and wear.
6) Inspect the engine fuel tank for damage or leaks.
7) Check telescopic boom wear pads and nylon studs (if applicable).
3.3.4 ANNUAL SAFETY CHECKS
1) Check that all pivot pins and their tag bolts are secure.
2) Inspect for any cracks or badly rusted areas on booms and chassis.
3) Change the hydraulic oil filters.
4) Check the bushes in the front wheel hubs for wear.
5) Check that rotation ring bolts are secure (torque 205ft lbs. 279Nm).
Toughcage
Niftylift toughcage is fully UV stabilised for outdoor use in the most demanding climates. However, the
user and machine owner should consider the following;
Discolouration of the material may occur; this is a natural aging process which does not
significantly alter the material properties.
Degredation to the floor may occur as a consequence of product use and effect of UV exposure.
The toughcage’s multi-layer construction means degradation of the top surface may occur over
time without compromising the structural strength of the internal and base layers.
The rate at which the toughcage floor ages is dependant upon the machines application and its
country of use (Typical levels of UV exposure). Refer to table below for aging rate applicable to your
specific area.
UK, NETHERLANDS, GERMANY, POLAND, SCANDINAVIA, CANADA, RUSSIA
FRANCE, ITALY, USA (NORTH EAST STATES)
SPAIN, GREECE, TURKEY, CHINA, USA (MID WEST STATES), AUSTRALIA (TASMANIA)
To Next Page
Loading...
