nifty SP45 - Inspection;Service;Pre-Hire Check List

SP Series
Operating & Safety Instructions
USA – 11/14
Original instructions
39
6.3 INSPECTION/SERVICE/PRE-HIRE CHECK LIST
MACHINE SERIAL NO
TOWING
PASS
FAIL
N/A
Machine secured on trailer
Straps correctly positioned and tightened
Wheels chocked if necessary
AXLES, WHEELS AND BRAKES
Wheels are secure, tire condition acceptable
Wheel bearings O.K.
Brake linkages and cables secure
Brake shoe wear not excessive
Machine climbs slope
Brakes hold machine on slope
Rear hub nut secure
Track rod secure, not fouling axle plate
BASE
Operation of ground control valve and buttons
Operation of all booms over full range
Wheel bearings OK
Cylinders are silent
Basket is level over full range
Booms, levelling rods not damaged or distorted
Booms levelling rods, cylinders not fouling
Hoses not tight, kinked or fouled
Operation of manual hand pump
BOOM ROTATE
Boom rotation assembly and motor are secure
Worm/wheel mesh correct, no excessive wear
No end float of worm in housing
Rotation wheel bolts secure
Rotation guards secure
BASKET
Operation of control valve and buttons
Operation of SiOPS
Levelling lock valve holds in both directions, lines vented
Operation of all booms over full range
Cylinders are silent
Basket levelling over full range
Boom rotation smooth over full range
Operation of boom 4 over full range (if fitted)
No excessive movement of boom 4 and boom 3