Why is the image quality on my Nightfox Monocular poor?
If the image on your Nightfox Monocular's LCD screen is blurry, first, adjust the eye relief and focus dial. If using it during the day, ensure the IR is turned off. At night, select an IR level from 1 to 5. If there is some ambient light, use “Lunarsight” (IR0). If “Disable IR LEDs” is selected, IR will not increase above IR0; reset this in the Settings mode under IR settings.
How to focus my Nightfox Monocular?
If your Nightfox Monocular picture is out of focus, rotate the diopter at the front of the unit to sharpen the image.
What to do if my Nightfox Monocular has frozen?
If your Nightfox Monocular unit has frozen and does not respond when any buttons are pressed, plug the unit in and leave it to charge. Then, press the reset button located above the USB-C port.
What to do if my Nightfox Monocular only powers on briefly?
If your Nightfox Monocular powers on briefly or not at all, plug the unit in and leave it to charge, even if nothing shows on the screen. After an hour, try turning it on again. This should resolve the issue if insufficient battery power is the cause.
What to do if my Nightfox Monocular says 'No SD card'?
If your Nightfox Monocular displays “No SD card” even when an SD card is inserted, enter Settings mode and format the memory card. This is because the inserted memory card is not formatted correctly or has corrupted.
To Next Page
General