93
t
4
Frame your subject and shoot.
Press the shutter-release button all
the way down to shoot the burst.
D
Continuous Mode
A mechanical shutter is used for pictures taken when I is selected and
Off is selected for Silent photography in the setup menu (0 212). An
electronic shutter is used for pictures taken at other settings. If the
built-in flash or optional flash unit fires when I is selected, only one
picture will be taken; at settings of 10, 20, 30, and 60 fps, the built-in
flash and optional flash units will not fire.
While photographs are being recorded to the memory card, the mem-
ory card access lamp will light. Depending on shooting conditions and
memory card write speed, recording may take some time. If the battery
is exhausted before all photographs are recorded, the shutter release
will be disabled and the remaining images transferred to the memory
card.
Continuous shooting is not available in creative, best moment capture,
advanced movie, or Motion Snapshot mode or when live image control
is used in auto mode (0 47).
A
Buffer Size
The camera is equipped with a memory
buffer for temporary storage, allowing shoot-
ing to continue while photographs are being
saved to the memory card. The approximate
number of images that can be stored in the
memory buffer at current settings is dis-
played while the shutter-release button is
pressed halfway (this number is an approximation only and varies with
shooting conditions). The illustration shows the display when space
remains in the buffer for about 40 pictures.
A
Single Frame
To take only one picture each time the shutter-release button is
pressed all the way down, press 4 (C) and select 8 (single frame) for
release mode.
To Next Page
Loading...
Need help?
General
