Nikon Eclipse E400 POL - Microscopic Procedure

Microscopic Procedure
The general procedure for microscopy is described below.
For del
ils on each step, refer to the
orresponding item in chapter “3. Operation of Басі
s р!
If the microscope has not yet been assembled, see chapter “4. Assembly" first
Turn on the power.
(Flip the switch to the “17 side.)
As soon as the power comes on,
the switch lights.
Set the brightness adjuster to give
B the desired brightness.
Pressing the auto-photo switch will
set the voltage for the brightness
that provides the best color
reproduction. (p.21)
Insert filters NCBI 1 into the
optical path.
NCBI1 improves color
reproduction. (p.20)
Push in the analyzer slider of the
intermediate tube to remove the
analyzer from the optical path.
Put the Bertrand lens turret in the
Bertrand lens from the optical
path
E Flip the switch to the “| " side.
Insert filters.
E Adjust the brightness.
Auto-photo switch can be pressed.
Push in the
analyzer slider.
Turn the turret to
the "O" position.
~