Nikon Eclipse E400 - Power Cord and Accessory Connections; Connecting the Power Cord Safely; Installing Separately Sold Accessories

© Connecting the power cord
ANT
Use only the following power supply cord set.
© For 100-120V area
UL
Listed,
detachable
cord
set,
3
conductor
grounding
type
SVT,
No.
18
AWG
rated
at
125V,
7A
minimum.
In
case
of
using
the
extension
cord,
use
only
the
power
supply
cord
with
the
PE
(protective
earth)
wire.
© For 220-240V area
3 pole power supply cord set, which must be approved according to EU/EN standards.
Class I equipment should be connected to PE (protective earth) terminal.
In case of using the extension cord, use only the power supply cord with the PE (protective earth) wire.
Turn off the microscope power switch by flipping it to the “ " side before connecting the power cord.
After
plugging
the
socket
onto
the
AC
input
connector
on
the
back
of
the
microscope,
securely
insert
the
plug
into
an
AC
outlet.
Oo Separately sold accessories installation
Install photomicrographic eguipment and other separately sold accessories by referring to the instruction manual for each
accessory.