Chapter 8 Functions and Operations of the Devices
94
Focus knobs on the remote controller
Turning the knob backward: Upward movement of the focus mount
Turning the knob forward: Downward movement of the focus mount
• Focusing stroke: 100 mm
Pedals of the foot switch
Left rear pedal: Upward movement of the focus mount
Left front pedal: Downward movement of the focus mount
For details about the pedal operations, see “10.2 AZ-FSW Foot Switch” in this chapter.
DISPLAY
BRIGHTNESS
ESCAPE
ALZ
−+
LIMIT
ZOOM
STEP
Z-RESET
Z-SPEED
ZOOM STEP
Coarse
FL Cube
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Fine
Ex Fine
1x
0.5x
0.1x
+
−
Focus operation
Focus speed
The focus speed can be switched between coarse, fine, and extra fine control.
Use the fine/coarse focus switching button on the remote controller to switch the speed.
Each time the button is pressed, the focus speed is cyclically switched in the order of coarse, fine, and extra fine.
When the focus speed is changed, the corresponding indicator (Coarse/Fine/ExFine) lights.
• Coarse: 2 to 10 mm/second
• Fine: 0.2 to 5 mm/second
• Extra fine: 0.01 to 0.1 mm/second
Forced stop of motorized movement
The motorized focus unit is equipped with the STOP switch on the
left side. Pressing the switch causes motorized movement to be
forcibly stopped. To resume the motorized movement, perform the
following steps:
1. Press the STOP switch again.
2. Turn off the power by pressing the power switch of the
P2-CTLB Control Box to the “” position.
3. Turn on the power by pressing the power switch to the “|”
position. (After the power on, initialization at power on is
automatically performed.)
Fine/coarse focus
switching button
Z-reset button
Focus knob
Limit button
Limit ON/OFF indicator
Focus knob
Focus speed indicato
Escape button
Escape ON/OFF indicato
Upward movement
Downward movement
Left rear pedal
(Upward movement)
Left front pedal
(Downward movement)
STOP switch
Fine/coarse focus
switching button
To Next Page
Loading...
