Chapter 7 Specific Operations
72
4
Adjusting the Angle of Depression
When the P2-TERG 100 Trinocular Tilting Tube or P2-TERG 50 is
used, the angle of the binocular part to facilitate microscopy can
be changed and adjusted.
The angle can be continuously changed by moving the binocular
part as indicated by the arrow in the figure.
The eye level can also be changed by turning the binocular part
180°.
(The low eye level P2-TL100 Trinocular Tube L does not have a
mechanism for adjusting the angle of depression.)
Adjusting the angle of depression
Notes on adjusting the angle of depression
• Do not apply excessive force to the binocular part during depression angle adjustment. It may cause unexpected failure or
malfunction.
• When moving the binocular part, be careful not to catch your fingers in the rotary section at the bottom of the binocular part.
5
Adjusting the Diopter
Adjust to match your diopter. This adjustment is required for each user.
1 Position the diopter adjustment rings of the right and left
eyepieces to 0.
DISPLAY
BRIGHTNESS
ESCAPE
ALZ
−+
LIMIT
ZOOM
STEP
Z-RESET
Z-SPEED
ZOOM STEP
Coarse
FL Cube
ON/OFF
ON/OFF
ON/OFF
ON/OFF
Fine
Ex Fine
1x
0.5x
0.1x
+
−
Remote controller
Foot switch
Adjusting the diopter
2 Maximize the magnification, and then focus on the sample
using the focus knob.
(See “7 Focusing on the Sample.”)
3 Minimize the magnification, and then turn the diopter
adjustment rings of the right and left eyepieces to bring
them into focus separately.
[Image zooming]
SMZ18 Zooming Body: Zoom knob on the zooming body
SMZ25 Zooming Body: Zoom buttons on the remote
controller or the right pedal of the
foot switch
[Zoom magnification]
SMZ18 Zooming Body: 0.75x to 13.5x
SMZ25 Zooming Body: 0.63x to 15.75x
4 Repeat steps 2 and 3 to check the focus, so that changing
the magnification does not affect the focus and clear images
can be captured.
Magnification
decrease
Magnification
increase
Magnification
increase
Magnification
decrease
Magnification
decrease
Magnification
increase
To Next Page
Loading...
