Nikon SMZ25 - Switching Objectives (Using the P2-RNI2 Intelligent Nosepiece)

Chapter 7 Specific Operations
77
Total magnification
The total magnification of the microscope is determined from the formula below:
Total magnification = zoom magnification x object’s magnification x eyepiece’s magnification
• When using a vertical tube, replace the eyepiece’s magnification with the C mount adapter lens’ magnification to
calculate the total magnification.
* Also see Chapter 8, “1 Zooming Bodies.”
8.2
Switching Objectives (Using the P2-RNI2 Intelligent Nosepiece)
The P2-RNI2 Intelligent Nosepiece can be attached with two of
the following objectives: P2-SHR Plan Apo 0.5X, 1X, 1.6X and
2X. The attached objectives can be switched by turning the
nosepiece. Check that the objective falls into the click position
when turning the nosepiece.
 Stereoscopic view and vertical view
An intelligent nosepiece has two click positions for each
objective.
The click position switches between stereoscopic view and
vertical view. Microscopy with vertical view is possible when
needed, for example when taking a picture.
The click position of the objective can be checked by the
position of the objective viewed from the front or the color of
the hole on the objective status display area on the intelligent
nosepiece.
* Also see Chapter 8, “3.1 P2-RNI2 Intelligent Nosepiece.”
Switching Objectives
1 x
SHR Plan apo WD:60
2 x
SHR Plan apo WD:20
2 x
SHR Plan apo WD:20
1 x
SHR Plan apo WD:60
Stereoscopic view Vertical view
Objective position state (stereoscopic view and vertical view)
Objective on the
o
p
tical
p
ath
Objective state
indication
Objective state
indication
White White
Black