Chapter 3 Assembling
25
(2) Place the focus unit in the recession of the
polystyrene piece as show in the figure.
Fitting the focus unit
(3) Hold the base with the two base side positioning
holes aligned with the two positioning pins on the
focus unit, screw the four M8 hexagon socket head
bolts (supplied with the focus mount) from the
bottom of the base and tighten firmly using the hex
wrench (nominal designation: 6).
Attaching the base by tightening the bolts
(4) Install the attached device on the desk.
Installing the base
Attaching the stage plate
ttach the stage plate.
Depending on the type of the base, either a transparent glass stage plate or an acrylic stage plate is supplied.
The acrylic plate is black on one side and milky white on the other side. Attach the stage plate with the appropriate
side facing up according to the sample to be viewed.
Positioning
pins
To Next Page
Loading...
