Chapter 3 Assembling
27
2
Attach an intelligent nosepiece or focus mount adapter.
ttach the intelligent nosepiece or focus mount adapter to the focus unit.
The attachment procedure is the same for both the intelligent nosepiece and focus mount adapter.
The following figure shows an example of attaching the intelligent nosepiece to the P2-FU Focus Unit.
(1) Remove the two rubber caps from the fixing bolt
holes at the right rear of the intelligent nosepiece (as
viewed from the front). Insert the hex driver (nominal
designation: 4) and completely loosen the two
internal M5 hexagon socket head bolts.
(2) Drop and fit the dovetail groove on the rear side of
the intelligent nosepiece onto the dovetail of the
focus unit mount from the top.
Attaching the intelligent nosepiece
(3) Firmly tighten the two fixing bolts using the hex
driver (nominal designation: 4). After tightening the
bolts, put the rubber caps back onto the bolt holes.
Firmly tightening the bolts
(4) The cover on the left side (as viewed from the front)
of the intelligent nosepiece is a sliding cover.
Removing this cover at this point will facilitate the
cable connection and routing in “[4] Connect signal
cables.”
Remove the rubber caps from the two fixing bolt
holes at the bottom of the cover, loosen and remove
the two internal M5 hexagon socket head bolts using
the hex driver (nominal designation: 4), and pull the
cover up to remove it.
To Next Page
Loading...
