Chapter 3 Assembling
44
2
Attach a focus mount.
ttach the P2-FMDN Focus Mount to the stand.
Insert the focus mount to the support pillar from the top
until it reaches the limit, and tighten the fixing knob on the
rear side.
Attaching the focus mount by tightening the knob
Focus mount orientation
ttach the focus mount so that it faces the front of the
stand as shown in the figure.
Correct orientation of the focus mount
CAUTION
If the focus mount is attached in the incorrect
orientation, the stand may fall over. This may result in
damage to the device or unexpected injury. Do not
attach the focus mount if the focus mount does not
face the front of the stand as shown in the figure.
Incorrect focus mount orientation
To Next Page
Loading...
