Nikon WP-N3 - The Final Leak Test; Final Leak Test Procedure

17
En
The Final Leak Test
The Final Leak Test
After inserting the camera and closing the case, perform a  nal check for
leaks.
D
Important!
Before use, be sure that the camera is functioning normally and that the case does not leak.
Failure to check for leaks before use could result in irreparable damage to the camera.
Immerse the case in water and check for leaks as
described in “The Preliminary Leak Test” (
0
11).
After completing the test, open the case and
check that the desiccant is dry and that no water
has entered. If a leak is detected, immediately
dry the camera and case thoroughly and check
that the O-ring is intact and the case properly sealed. If the cause of the
leak can not be determined, take the case to a Nikon-authorized service
representative.