nilan VPL 15 User Manual

This document may be subject to change Side 17 of 23
Inlet control
In the ”Inlet control” menu it is possible to adjust the period of time before restart of the compres-
sor.

The ”Inlet control” menu should only be adjusted by persons with knowledge of control
engineering. (To restore factory settings, see page 19)
” ” indicates that the menu point flashes and can be set to another value
Use of t he CTS 600 panel :
- pr ess ESC t o go one st ep back i n t he menu
- pr ess qpt o move up or down i n a menu or t o
adj ust an act i vat ed menu
- pr ess ENTER t o act i vat e a menu
- pr ess ENTER t o conf i r m a menu
- pr ess OFF t o t ur n of f t he uni t
- pr ess ON t o t ur n t he uni t on
TEMP.
CONTROL
HOTWATER
AIR
EXCHANGE
DEFROST
SERVICE
ENTER
RESTART
OFF
MANUAL
OFF
PRESET
OFF
ROOM
CONTROL
INLET
CONTROL
HEATPUMP
RST ”6m”
The minimum length of
time (in minutes) the
compressor must be
stopped before
restarting.
GAIN
7.0%/°
INTEGRAL
120s
N- ZONE
2.0°C
TMP-RAMP
0.10°/s
KAP- RAMP
0.5%/s
ENTER
The menu options are
only accessible when
the system has a post-
heating element
Figure 12: The "Inlet control" menu

nilan VPL 15 Specifications

General

Brand	nilan
Model	VPL 15
Category	Control Panel
Language	English