nilan VPL 15 User Manual

This document may be subject to change Side 18 of 23
Room control
In the ”Room control” menu it is possible to adjust the regulator for controlling the room tempera-
ture.

The ”Room control” menu should only be adjusted by persons with knowledge of control
engineering.
” ” indicates that the menu point flashes and can be set to another value
Use of t he CTS 600 panel :
- pr ess ESC t o go one st ep back i n t he menu
- pr ess qpt o move up or down i n a menu or t o
adj ust an act i vat ed menu
- pr ess ENTER t o act i vat e a menu
- pr ess ENTER t o conf i r m a menu
- pr ess OFF t o t ur n of f t he uni t
- pr ess ON t o t ur n t he uni t on
ROOM
CONTROL
TEMP.
CONTROL
HEATING
AIR
EXCHANGE
DEFROST
INLET
CONTROL
SERVICE
ENTER
RESTART
OFF
MANUAL
OFF
PRESET
OFF
ENTER N-ZONE
2.0°C
SURFACE
Heat demand:
Neutral Zone for start
and stop of the
evaporator:
Desired room
temperature (21°C) +
N-ZONE (2°C) = 20°C
for start of the
evaporator, 22°C for
stop of the evaporator
Can be set from
0,5-10°C.
Figure 13: The "Room control" menu

nilan VPL 15 Specifications

General

Brand	nilan
Model	VPL 15
Category	Control Panel
Language	English