2 2
2 2
2 - FORM NO. 56043093 / Captor
™
4300, 4800, 5400 / CR 1100, 1200, 1400
TRANSPORTING THE MACHINETRANSPORTING THE MACHINE
TRANSPORTING THE MACHINETRANSPORTING THE MACHINE
TRANSPORTING THE MACHINE
CAUTION!CAUTION!
CAUTION!CAUTION!
CAUTION!
Before transporting the machine on an open truck or trailer, make sure that . . .
••
••
• All access doors are latched securely.
••
••
• The machine is tied down securely - see tie-down locations
((
((
(
66
66
6
))
))
).
••
••
• The machine parking brake is set.
TOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINE
TOWING OR PUSHING A DISABLED MACHINETOWING OR PUSHING A DISABLED MACHINE
TOWING OR PUSHING A DISABLED MACHINE
CAUTION!CAUTION!
CAUTION!CAUTION!
CAUTION!
The machine’s drive propelling pump is manufactured with a selectable tow valve. This valve prevents damage to the hydraulic
system when the machine is being towed/pushed short distances without use of the engine.
To access the valve, open the Engine Compartment Door
((
((
(
2222
2222
22
))
))
) and lift off the Right Engine Compartment Access Panel
((
((
(
3737
3737
37
))
))
). Locate
the valve as shown on the underside of the hydrostatic pump by reaching under the radiator. Turn the valve 90 degrees, this
disengages the hydrostatic lock between the motor and pump.
The hydrostatic pump can be damaged if the machine is towed with the valve in the normal working position
(A)(A)
(A)(A)
(A). Reference the
illustration below for the normal working setting
(A)(A)
(A)(A)
(A) and the free wheeling towing setting
(B)(B)
(B)(B)
(B). Note: If the tow valve is left in free
wheeling
(B)(B)
(B)(B)
(B) position the hydrostatic pump can’t drive the machine FWD or REV. No damage will result, just re-set valve to the normal
working setting
(A)(A)
(A)(A)
(A). Tow or push machine no faster than a normal walking pace (2-3 miles per hour) and for short distances only.
If the machine is to be moved long distances the drive wheel needs to be raised off the floor and placed on a suitable transport dolly.
OTHER MANUALS AOTHER MANUALS A
OTHER MANUALS AOTHER MANUALS A
OTHER MANUALS A
VV
VV
V
AILABLEAILABLE
AILABLEAILABLE
AILABLE
The following manuals are available from the Nilfisk-Advance Literature Service Department, for your Rider Scrubber/Sweeper:
••
••
• Parts List - Form Numbers 56042440 (all systems except hydraulic)
56042445 (hydraulic system)
••
••
• Operation Manual - Form Numbers 56041546 (Danish, Norwegian, Swedish, Finnish)
56041547 (English, German, French, Netherlands)
56041548 (Spanish, Portuguese, Italian, Greek)
• Mechanical Repair Service Manual 56043094
BOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROST
BOTTOM VIEW OF HYDROSTBOTTOM VIEW OF HYDROST
BOTTOM VIEW OF HYDROST
AA
AA
A
TIC PUMPTIC PUMP
TIC PUMPTIC PUMP
TIC PUMP
GENERAL INFORMAGENERAL INFORMA
GENERAL INFORMAGENERAL INFORMA
GENERAL INFORMA
TIONTION
TIONTION
TION
To Next Page
Loading...
Need help?
General
