Nilfisk-Advance CR 1200 User Manual

A-English
CR 1100, CR 1200
Instructions for Use
11/08 revised 9/10
FORM NO. 56041776
Nilfi sk Models: 56303004 (CR 1200), 56303005 (CR 1100 / OBS)

Nilfisk-Advance CR 1200 Specifications

General

Brand	Nilfisk-Advance
Model	CR 1200
Category	Scrubber
Language	English

Summary

Introduction

Parts and Service

Information on obtaining repairs and original replacement parts for the machine.

Nameplate

Location and importance of the model and serial number for service and parts.

Un-crating

Steps for inspecting and removing the machine from its shipping crate.

Cautions and Warnings Symbols

General Safety Instructions

Important safety guidelines to prevent injury and machine damage during operation.

Hopper Safety Support

Jacking the Machine

Precautions and correct locations for safely lifting or jacking the machine.

Transporting the Machine

Steps to ensure the machine is secured properly for transport on a trailer or truck.

Towing or Pushing a Disabled Machine

Guidelines for safely towing or pushing the machine if it becomes disabled.

Battery Installation

Know Your Machine

Control Panel

Operator's Compartment

Pre-Operational Checklist

Scrub Brush Installation

Step-by-step guide for removing and installing scrub brushes or pad holders.

Main Broom

Filling the Solution Tank

General Use

How to operate the detergent dispensing system and interpret its status indicators.

To Purge Weekly

Procedure for purging the detergent system weekly to maintain optimal performance.

Detergent System Preparation and Use (EDS Models Only)

Operating the Machine

Sweeping

Detailed instructions for performing the sweeping operation effectively and safely.

Emptying the Hopper

Steps for safely raising the hopper and emptying collected debris into a receptacle.

Scrubbing

Emptying the Recovery Tank

Procedure for draining and flushing the machine's recovery tank after use.

After Use

Maintenance Schedule

A comprehensive schedule outlining routine maintenance tasks and their recommended intervals.

Charging the Battery

Checking the Battery Electrolyte Level

How to check and maintain the electrolyte level in the battery cells for optimal performance.

Main Broom Maintenance

Side Broom Maintenance

Squeegee Maintenance

Hopper Dust Control Filter

Hydraulic Oil

Guidance on checking and changing the hydraulic oil and identifying the hydraulic filter.

Drive Wheel Gear Case Oil

Lubrication

Locations for grease fittings and oil for machine lubrication points.

Circuit Breaker Location

Identification of the location and ratings of the machine's circuit breakers.

Troubleshooting

Technical Specifications