3
1)
Options / model variants
Original instructions
3 Before starting the cleaner
3.1 Setting up the cleaner Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by weight) for proper
combustion. Therefore some
adjustment of the air regulation
to the burner may be necessary
to take account of altitude and
the resulting air pressure. This
is true whether your fuel is ‘Nat-
ural gas’, Propane or Diesel.
Your Nilfisk hot water pressure
washer was thoroughly tested
and adjusted for optimum per-
formance before it left our fac-
tory. The factory is located at ap-
proximately 120m (390 ft) above
sea level, and the combustion
settings are optimal for that el-
evation.
If your location is higher than
1200m (3900 ft) above sea lev-
el, your burner may require re-
adjustment for proper perfor-
mance and best fuel economy.
Contact your Dealer or Nilfisk
for assistance.
3.2 Set the brake 1. Before using the cleaner for
the first time, check it care-
fully to detect any faults or
damage.
2. Run the machine only when
it is in perfect condition.
3. Set the brake.
4. The slope of which the high
pressure cleaner is placed
must not exceed more than
10° in any direction.
To Next Page
Loading...
Need help?
General
