Nilfisk-Advance SMART User Manual

3
2
OPERATING THE CLEANER
2-1 POWER CORD
2-2 POWER-CONTROL (INFRARED-CONTROL)
HANDLE CONTROL BODY CONTROL
NOTE
1. When using the control button for suction power, make sure that the transmitter of the
remote controller not be blocked by your body.
2. When operating the cleaner in a room with a high ceiling or under intensive light, the suc-
tion power controlling button may not work properly. So, use the "Power Control" button on
the main body.
3. When the battery is run down, it does not work with the button pressed on the handle
control part. In this case, replace the battery. (How to change: Refer to User Manual No.6)
NOTE
When removing the
plug from the
electrical outlet, grasp the
plug, not the cord.
SENDER
Press Power Control on the main
body to turn on the power (MAX).
And, press it again to turn it off (STOP).
DJ68-00316B(NILFISK)-EN 4/15/05 8:57 PM Page 3

Nilfisk-Advance SMART Specifications

General

Brand	Nilfisk-Advance
Model	SMART
Category	Vacuum Cleaner
Language	English