Nilfisk-ALTO ATTIX 3 - Picking up Dry Substances; Picking up Liquids; After Finishing Work; Switching the Vacuum Cleaner off and Storage

6
1)
Option depending on model
english
ATTIX 3 / 5 / 7 / 12 GALLON / 19 GALLON
7
1)
Option depending on model
english
ATTIX 3 / 5 / 7 / 12 GALLON / 19 GALLON
5.1.1 Picking up dry
substances
CAUTION!
Do not pick up ammable
substances.
Before picking up dry sub-
stances, always ensure that a
lter bag is inserted in the tank
(see section 9.5 "Accessories"
for order number). Disposal of
the picked up material is then
simple and hygienic.
After picking up liquids, the lter
element is wet. A damp lter
element clogs more quickly
when dry substances are
picked up. For this reason the
lter element should be washed
and dried or replaced by a dry
element before dry substances
are picked up.
5.1.2 Picking up liquids CAUTION!
Do not pick up ammable
liquids.
Before liquids are picked up,
always remove the filter bag/
waste bag and check that the
float
1)
or the water level limit
1)
works properly. (See section
7.2.4 and 7.2.5 “Replacing the
filter element“.)
The use of a separate lter ele-
ment or lter screen is recom-
mended.
If foam appears, stop work im-
mediately and empty the tank.
To reduce the amount of foam,
use foam killer Alto Foam Stop
(see section 9.5 "Accessories"
for order number).
6 After finishing work
6.1 Switching the vacuum
cleaner off and storage
1. Switch off the vacuum
cleaner and pull the mains
plug out of the socket.
2. Wind up the power cord and
hang it on the handle.
3. Empty the tank and clean
the vacuum cleaner.
4. After picking up liquids:
Store the upper section of
the cleaner separately so
that the lter element can
dry.
5. Store the cleaner in a dry
room where it is protected
from unauthorized use.
ATTIX 12 GALLON
ATTIX 3
ATTIX 5
ATTIX 19 GALLON
ATTIX 7