9
1)
Option depending on model
english
ATTIX 3 / 5 / 7 / 12 GALLON / 19 GALLON
7.2.3 Emptying dirt tank
(ATTIX 3 / 5 / 12 GALLON)
1. Remove the upper section
of the cleaner from the dirt
tank.
2. Hold the dirt tank at the grip
underneath the tank and tip
out the dirt.
3. Dispose of the dirt in accord-
ance with legal regulations.
4. Clean the rim of the tank be-
fore tting the upper section
of cleaner.
Before reinserting the suction
hose:
5. Clean the inlet tting and
hose collar.
7.2.5 Replacing filter element
(Push&Clean System)
1)
1
2
3
1. Remove the upper section of
the cleaner from the dirt tank
and deposit with the lter
element facing upwards. Do
not place the upper section
of the cleaner on the guard
(1).
2. Turn the lter holder anti-
clockwise (2) and remove it
(3).
3. Carefully remove the lter
element.
7.2.4 Emptying the dirt tank (ATTIX
7/19 GALLON)
1. Remove the upper section of
cleaner from the dirt tank.
2. Open the retaining clamps
(1) and remove the interme-
diate ring (2) from the tank.
3. Pull the lever in the handle
(3) upwards and tilt the tank.
4. Tip out the collected dirt.
5. Dispose of the dirt in accord-
ance with legal regulations.
or:
1. Open the tank locks (4).
2. Use the handles (5) to lift the
tank out of the frame.
4. Tip out the collected dirt.
5. Place the empty tank in the
frame and close the locks
(4).
6. Dispose of the dirt in accord-
ance with legal regulations.
1
3
1
To empty the dirt tank after picking
up liquids: remove the intermediate
ring as a proper seal is only en-
sured during suction.
After emptying the tank: clean the
rim of the tank and the seals in the
intermediate ring and the upper
section of cleaner before refitting
them.
If the seal or groove is dirty or dam-
aged, the suction performance will
be reduced.
Before reinserting the suction hose:
clean the inlet fitting and hose col-
lar.
5
5
To Next Page
Loading...
