Nilfisk-ALTO ATTIX 961-01 User Manual (English)

Other manuals for Nilfisk-ALTO ATTIX 961-01

Questions and Answers:

B
Bonnie ParkerAug 1, 2025
What to do if my Nilfisk-ALTO ATTIX 961-01 motor does not start?
- C
  Chad ShafferAug 1, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor isn't starting, it could be due to a blown fuse in the mains socket. Try connecting a mains fuse. Another possibility is that the overload protection switch has tripped. In that case, switch off the vacuum cleaner and let it cool down for about 5 minutes. If it still won't start, the motor might be faulty and needs to be changed by Nilfisk-Alto Service.
K
Kimberly BeckerAug 11, 2025
Why does my Nilfisk-ALTO ATTIX 961-01 Vacuum Cleaner have reduced suction power?
- J
  Joel MaloneAug 11, 2025
  Reduced suction power in your Nilfisk-ALTO Vacuum Cleaner can occur for several reasons. It could be that the suction power is set too low, so adjust it according to the instructions. Also, check for clogs in the suction hose or nozzle and clean them if necessary. The tank, disposal bag, or filter bag might be full, so empty the tank or replace the bags. A clogged filter element can also cause this issue, so clean or replace it. Inspect the seal between the tank and the upper section of the vacuum cleaner; if it's faulty or missing, replace it. If none of these steps work, the cleaning mechanism may be defective, and you should contact Nilfisk-Alto Service.
D
Dawn WilliamsAug 20, 2025
Why Nilfisk-ALTO ATTIX 961-01 Vacuum Cleaner motor does not run in automatic mode?
- M
  Mark LloydAug 20, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor isn't running in automatic mode, the power tool or pneumatic tool may be defective or not properly connected. Ensure the power tool is working correctly and the plug is inserted properly. Also, the electrical tool's power rating might be too low; make sure it's above the minimum of P>40W.

Nilfisk-ALTO ATTIX 961-01 Specifications

General

Model	ATTIX 961-01
Brand	Nilfisk-ALTO
Category	Vacuum Cleaner
Vacuum	250 mbar
Container Capacity	50 l
Cable length	10 m
Hose Length	2.5 m
Mains connection	230 V
Filter Type	HEPA
Accessories Included	Crevice nozzle, Floor nozzle