EasyManuals Logo

Nilfisk-ALTO SCRUBTEC 8 User Manual

Nilfisk-ALTO SCRUBTEC 8
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
EN
ENGLISH
Nil sk ALTO Operator’s Manual (EN) - SCRUBTEC 866, 871, 866, Boost 8 and 871C FORM NO. 71492A - 17 -
Figure 16
Figure 17
HOW TO OPERATE THE MACHINE
How To Operate the Squeegee
The squeegee wipes the oor while the vacuum motor removes the
dirty solution from the oor. Use your hand to lower or raise the
squeegee handle. To operate the squeegee, follow this procedure:
1. To lower the squeegee rotate the squeegee lever down. See
gure 16.
2. To raise the squeegee, rotate the squeegee lever up. See
gure 16.
How to Fill The Solution Tank
1. Remove the solution tank lid. See gure 17.
2. If the machine does not have the Chemical Mixing System,
add a cleaning chemical to the solution tank. For the cor-
rect amount of chemical, follow the directions shown on the
container.
3. Fill the solution tank with water.
4. Replace solution tank lid.
WARNING: Water solutions or cleaning materials used
with this type of machine can leave wet ar-
eas on the oor surface. These areas can
cause a dangerous condition for the opera-
tor or other persons. Always put CAUTION
signs near the area you are cleaning.
WARNING: Machines can ignite ammable materi-
als and vapors. Do not use with or near
ammables such as gasoline, grain dust,
solvents, and thinners. Only use a clean-
ing concentration recommended by the
chemical manufacturer.
WARNING: Nil sk ALTO recommends a maximum
water temperature of 120°F(49°C)

Other manuals for Nilfisk-ALTO SCRUBTEC 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-ALTO SCRUBTEC 8 and is the answer not in the manual?

Nilfisk-ALTO SCRUBTEC 8 Specifications

General IconGeneral
BrandNilfisk-ALTO
ModelSCRUBTEC 8
CategoryScrubber
LanguageEnglish

Related product manuals