EN
ENGLISH
-4- FORM NO. 71492A Nilfi sk ALTO Operator’s Manual (EN) - SCRUBTEC 866, 871, 866, Boost 8 and 871C
WARNING: Electrical components of this machine can “short-out” if exposed to water or moisture. Keep the electrical compo-
nents of the machine dry. Wipe the machine down after each use. For storage, keep the machine in a dry building.
WARNING: To reduce the risk of fi re, when replacing fuse, replace only with same type and rating of fuse that comes with ma-
chine.
WARNING: Operating a machine without observing all labels and instructional information could result in injury or damage. Read
all machine labels before attempting to operate. Make sure all of the labels and instructional information are attached
or fastened to the machine. Get replacement labels and plates from your Nilfi sk ALTO distributor.
WARNING: Wet fl oor surfaces can be slippery. Water solutions or cleaning materials used with this type of machine can leave wet
areas on the fl oor surface. These areas can cause a dangerous condition for the operator or other persons. Always
put “Caution” signs around/near the area you are cleaning.
WARNING: Improper discharge of waste water may damage the environment and be illegal. The United States Environmental
Protection Agency has established certain regulations regarding discharge of waste water. Also, city and state regula-
tions regarding this discharge may be in your area. Understand and follow the regulations in your area. Be aware of
the environmental hazards of chemicals that you dispose.
CAUTION: Use of this machine to move other objects or to climb on could result in injury or damage. Do not use this machine as
a step or furniture. Do not ride on this machine.
CAUTION: Your machine warranty will be voided if anything other than genuine Nilfi sk ALTO parts are used on your machine.
Always use Nilfi sk ALTO parts for replacement.
Introduction :
Scrubtec 866, 871, 886, BOOST 8 and 871C automatic scrubbers are effi cient and superior fl oor cleaning machines. The Scrubtec
886 uses two brushes or pads to scrub a path 86 cm wide. The Scrubtec 871 uses two brushes or pads to scrub a path 71 cm wide.
The Scrubtec 866 uses two brushes or pads to scrub a path 66 cm wide. The Scrubtec BOOST 8 uses one pad or brush to scrub a
path 71 cm wide. The Scrubtec 871C uses two brushes to scrub a path 71 cm wide. A squeegee wipes the fl oor while the vacuum
motor removes the dirty solution from the fl oor in one pass.
Scrubtec 866, 871, 886, BOOST 8 and 871C automatic scrubbers come complete with three battery connector cables, one battery
cable, one battery charger and one operator’s manual.
To Next Page
Loading...
Need help?
General
