Ninja BL685

Assembly and Use of the Processor Bowl
A
WARNING : Chopping Blade Assembly is sharp and not locked in place. Before emptying contents carefully
remove lid and Chopping Blade Assembly , hold i ng it by the shaft. Failure to do will result in risk of
laceration .
A
WARNING: Remove utensils prior to process i ng. Failure to remove may cause the bowl to be damaged or to
shatter, which may cause personal injury .
A
WARNING: Never leave the appliance unattended while in use .
A
CAUTION : Do not blend hot li qu i ds, doing so may cause excessive pressure buildup, resulting in risk of the
user being burned .
A
CAUTION : Remove the lid from the bowl upon completion of process i ng. Some ingred i ents have the potential
to expand after blend i ng resulting in excessive pressure buildup that can pose a risk of i njury .
IMPORTANT : Make sure that the motor base is plugged in for use.
ASSEMBLY
Fig . 3a
Fig. 1 Fig . 2 Fig . 3b
1 Review warning and caution s tatements above before
proceeding to number 2.
2
Place the motor base on a clean , dry , level surface such
as a counter or table top .
3
Align and lower the Bowl onto the motor base .
(Fig . 1) Handle should be aligned slightly to the right of
the " LOCK " symbol on the motor base .
4
Rotate the bowl clockwise until you hear a click , you will
hear a click when the lock is engaged . (Fig. 2)
5 The bowl can be pla c ed on the motor base two ways ;
the handle can be on the front right corner or the front
left corner . (F i g. 3a, Fig . 3b)
6 Holding the desired blade assembly by the top of the
shaft , place it onto the drive gear inside the bowl.
Ensure that the blade assembly is seated properly and
is standing upright. (Fig. 4)
NOTE: The blade assembly will fit loosely on the drive
gear.
7 Add the ingredients to the bowl , making sure that they
do not ex ceed the highest measured marking line on
the side of the bowl.
BL685_Series_lB_ 170428_press.indd 9
OR
Fig . 4 Fig . 5
NOTE : The food processor bowl is not intended
for blending dr i nks . Do not overfill.
8 Holding the lid by the handle in the upright position,
place it on top of the bowl aligning the arrow (• )
located on the lid with the arrow (&) located on the
bowl's handle. (Fig. 5) Press the handle down until you
hear a click. I
NOTE : To add liquids during blending , open
the drizzle hole on the top of the lid and
pour the liquid slowly into the mi x ture .
9
Plug the power cord into the electrical outlet and press
the power button (C9) .
IMPORTAN T : As a safety feature, the power
button (c!.l) will flash and the motor will not work
if the bowl and lid are not installed correctly .
When the bowl and lid are i nstalled properly, the
power button (C9) will be solid , i ndicating that the
appliance is ready for use .
NOTE : Do not ex ceed the highest measured marking line
on the side of the bowl. For meats do not exceed 34 oz
bowl mark.
ninjakilchen.com [ 8
2017-05-01 9:08
AM I
Case 2:23-cv-02144 Document 1-1 Filed 03/20/23 Page 9 of 16 PageID #: 20