11
10 In order to obtain a better quality of
chopping, operate the appliance by
using the “pulse” method.
11 Make sure that the blades have
stopped completely before removing
the power head.
12 If the ingredients stick to the side
of the Master Prep
®
bowl, stop the
appliance, remove the power head
and the splash guard. Use a spatula to
dislodge the pieces and then replace
the splash guard and the power head.
Continue processing.
13 Remove the blade assembly by its shaft
before you empty the contents of the
Master Prep
®
bowl.
HINTS & TIPS
• The double chopping blades can be used
for chopping meat, fish, vegetables,
cheese etc.
• For finer chopping, increase the length of
time you process.
• For coarse chopping, use the pulse
button for a few seconds and monitor
food texture.
• Pre-cut larger pieces to make them
fit into the Master Prep
®
bowl. When
chopping hard foods (e.g. meat, cheese)
cut into 1-inch cubes.
5 Place the splash guard on the bowl.
(Fig. 3)
6 Place the power head on top of the
splash guard making sure that it is
securely in place. (Fig. 4) DO NOT
attempt to operate the appliance
without the safety splash guard in
place.
7 To start the appliance, plug the power
cord into the electrical outlet, securely
hold power head while operating
and press on the on/off pulse button
located on the top of the power head.
(Fig. 5)
8 Hold the Master Prep
®
bowl firmly while
depressing the on/off pulse button to
ensure the unit stays in place.
NOTE: DO NOT operate the appliance
continuously for more than 15 seconds
at a time. Be careful not to over
process. For coarsely chopped foods,
use repeated short pulsing action until
the desired consistency is reached.
9 To stop the appliance, remove your
fingers from the on/off pulse button.
5
3
4
To Next Page
Loading...
Need help?
General
