NIZ ATOM 68 - USB, PS;2 Interface Settings; Keyboard Configuration; Backlight Configuration; Keyboard Modes and Customization

same device. At this time, please turn off the Bluetooth device, and then re pairing one of the
bluetooth.
4. Battery indicator:
The battery indicator is below in the F12button. Always on for charging; Always off for
charging completion; flash for low power.
USB,PS/2 Interface settings
Press “FN + Backspace” for 5seconds ,indicator flash 1 times to USB, indicator flash
2 times to auto identify for USB,PS/2.and restart the keyboard.The default settings is
set to USB.
Bluetooth Sleep and Power down settings
Press “FN + T” for 5seconds ,indicator flash 1-3 times are power down time set to 1-3
hours.The default power down time is set to 1 hours.
Clear Key Counter
Press “FN + Delete” for 5seconds ,indicator flash,and the key counter will be clear .
Restore factory settings
Press “ESC + L-ctrl + ~`+ Right” for 5seconds will restore factory settings, restore
factory settings will restart keyboard.
2．Keyboard configuration
There are two modes for the keyboard, OFFICE mode and Custom mode.
OFFICE mode is also Standard mode, as for Custom mode, you can make different
configuration to the keyboard, the details for how to configuration and save under
custom mode are in below.
※
NOTE
：
Press the “Save” of main screen to save the configure when the configure be
completed.
How to configure backlight:
Single click the “LightSet” Key in the main screen of Programming software, the
dialog box of “Backlight settings panel” will pop out.
Single press “Set All” key, choose the color in the dialog box of “color” that pops out
and confirm. Then fast set up all the key color as the chosen color.
Single press “Multi key”key,the dialog box of “Set Multi Key panel” will pop