nokia
CONNECTING PEOPLE
PAGE 12 (18) Approved 2.0
CMO Operations & Logistics
MWy
WW Service Solutions & Development
Confidential 16.06.2005
Bochum / Germany
Service Manual 1100/1101 Level 1&2 Copyright 2003-2005 © Nokia Corporation
8. DOME SHEET EXCHANGE
Use SRT-6 to loosen one corner of the Dome Sheet.
Tear off Dome Sheet in diagonal direction to avoid
remains of glue. Check pads for cleanness.
Take a new Dome Sheet from carrier film. Do not touch
the keydomes from adhesive side.
Use the guiding pin and the C-Cover’s edge as
reference point.
Carefully place Engine Module from topside on. Note
the guiding pin.
Before sinking the Engine Module, make sure that it is
also close to the same side of the shielding.
Carefully press-on the Dome sheet to the Engine
Module to avoid bubbles.
Finally check, if the holes of the Dome Sheet match
exactly to the ones in the Engine Module. Otherwise
change Dome Sheet again! Check Keyboard
functionality.
To Next Page
Loading...
