6/18
4.1.3 Password
Password is an optional parameter that could be used if a user wants to secure system e.g.
in case that commands will be accepted from several phone numbers. The parameter
accepts 0-8 characters (ASCII character range 0x20-0x7E) e.g. password. The password is
case sensitive (see Figure 1).
Figure 1 User Control mode dialog in the Nokia 30 Configurator.
4.2 INPUT MODE AND INITIAL OUTPUT STATE
Input modes and initial output states can be configured with the Nokia 30 Configurator by
opening menu option Remote I/O control -> General.
Each of the inputs can be configured as digital or analog depending on the nature of the
device being monitored. If the information available from the device is on-off information, the
input should be configured as digital. If in turn the information is of a continuous nature, the
input should be analog. (See Figure 4 for a view of the Nokia 30 Configurator for Input
settings).
It is possible to subscribe events as alarms to a specific phone number. In the case of digital
input an alarm can be triggered when the state of the digital input changes. In the case of
analog input low and high limits and a period for checking the input state can be set. For
more information about subscribing input events, see chapter 7.2.3.
To Next Page
Loading...
