Nokia 30 - Controlling Power Supply to the Device

18/18
7.2.6 Controlling Power supply to the device
Power output can be used to supply power through the Nokia 30 to the application. The
Supply_Pwr commands are used to read/write power supply line states (see Table 8).
Table 8 Supply_Pwr commands
Command type Command template Comments
Supply_Pwr_Get
Nokia30 Supply_Pwr_Get
Response:
SUPPLY_PWR_GET: X
The X refers to either ON or OFF.
The command reads the power
supply line state and the response
returns the state of it
Supply_Pwr On
Nokia30 Supply_Pwr On
Response:
SUPPLY_PWR ON: OK
The command sets the power
supply line to ON state and a
response returns the confirmation
of it
Supply_Pwr Off
Nokia30 Supply_Pwr Off
Response:
SUPPLY_PWR OFF: OK
The command sets the power
supply line to OFF state and a
response returns the confirmation
of it