10
È
1999 Nokia Mobile Phones. All Rights Reserved.
2. Basic Functions
Making a Call
1
Key in the number (include the area code,
even if you are making a local call).
If you make a mistake you can delete the last num-
ber by pressing or clear the whole display, by
pressing and holding for half asecond.
2
Press (Call).
The indicator and the dialled number
will
appear on the display. Also the name of the per-
son you are trying to call appears on the display
for 5 seconds, if it is stored in the phone’s mem-
ory. When the number clears from the display
and a tone is heard, the phone has transmitted
the number.
3
Lift the phone to your ear, and wait until
your call is answered, then speak.
4
When you have finished the call, press
(End).
If the message LOCKED appears on the display,
your phone has been locked (see ‘Phone Set-
tings, Phone Lock’). When the phone is locked,
calls may be possible to the emergency number
preprogrammed into your phone (e.g. 112 or
some other official emergency number).
Also all calls may be received (see ‘The Phone
Book’).
To redial the last number called:
1
Press and (Redial) or
2
by first pressing and keys and
then (Redial) .
International Calls
Note: This function is operational only if thelo-
cal network supports it. Check with the network
service operator.
When calling abroad a + character can be inserted
in front of the country code instead of the interna-
tional access code.
For example, when calling abroad from Finland,
instead of dialling
990 010 81 123 456
+ 010 81 123 456 can be used.
1
Press the key twice to insert
a + character.
If you also store all of your domestic phone num-
bers with the prefix +, you need not insert the
phone number with the international access codes
when you wish to call these numbers from abroad.
If the network does not support this function, a
message PREFIX + CANNOT BE USED may appear
on the display. Then, the international access
code must be keyed in.
Receiving a Call
When there is an incoming call, you will hear
the ringing tone and the text CALL appears on
the display. If the ringing tone has been
switched off - the SILENT option has been se-
lected for privacy or other reasons - the lights
will flash instead and only a short beep will be
heard (see ‘Sound Settings, Ringing Volume’). An
easy way to select the SILENT option is to press
Menu and .
If the caller can be identified (if the network
supports this function), the caller’s phone num-
ber (or the name, if it is stored in the memory)
appears on the display together with the text
CALLING.
Note: This function, which enables the caller to
be identified, is operational only if the local net-
work supports it. Check with the network service
operator.
If the call is diverted from another number, the
> indicator appears on the right-hand side of
the third display row.
To Next Page
Loading...
