7368 ISAM ONT E-240G-B Product Guide Install an E-240G-B ONU
Issue: 01 3FE-46261-AAAA-TCZZA 65
vii Bolt the outdoor enclosure to the four mounting points on the cable storage
compartment using the supplied #8-16 X 1/2 self tapping screws; see Figure 22
and 24.
viii Go to step 6.
b If you are not using an FSST:
i Open the access cover on the outdoor enclosure by loosening the pin-in-hex
screw.
ii Secure the outdoor enclosure to the mounting area at the subscriber premises.
Use the appropriate hardware as defined by local installation practices. Mount the
outdoor enclosure using the specified mounting holes as shown in Figure 24.
Note — The access cover of the outdoor enclosure must be open to
access the three mounting holes used to secure the outdoor enclosure to
the wall.
Release 06.01.01 | June 2019 | Edition 09
To Next Page
Loading...
